Posted on 26 March 2020 - 12:55 PM

When your cape is set to the “Dynamic Curve” setting, the top will go into your armor when you sneak. I don’t think this happens with the other cape settings, just the Dynamic Curve one.

Last edited on 26 March 2020 - 04:35 PM by barronjacob

Hello, does this occur in 1.7 ? And if so, does it also occur in other versions ?

Posted on 26 March 2020 - 06:01 PM

I've tested versions 1.7.10 through 1.15.2 and the top of the cape will phase into the chestplate when it is set to "Dynamic Curve". I've also discovered that on "Curved Rectangle", a similar effect occurs, but higher up on the cape. When the cape is set to the "Rectangle" setting, this issue does not occur.

To replicate, turn the cloak type to either "Dynamic Curve" or "Curved Rectangle". Put on a chestplate. Go into the first F5 mode, where the camera is behind you and facing forward. Sneak, but do not move. Look at the top of the cape once it curves and the cape will phase into the chestplate.

Posted on 26 March 2020 - 06:14 PM

Ok, thank you. I did not know this was occuring in versions higher than 1.7, I'm reporting this to tech support.